HomePACESearch
 ProjectsForumsSite Map

Current:
Level Down:

Wiring Your XSA-100

Initial Wiring
Connecting power to the XSA-100 Board
  • Through one of several pins on the board, depending on which voltage you would want to use.
    Voltage Connect Pin # Notes
    +5V 2
    +3.3V 22 To use your own +3.3V supply, remove the jumper from J7. To use the +3.3 supply from the +5V supply, leave the jumper on J7
    +2.5V 54 To use you own +2.5V supply, remove the jumper from J2. To use the +2.5V supply from the +3.3V supply, leave the jumper on J2
    GND 52
  • Through a 9V DC wall-mount power supply
Other Connections
These connections should be pretty self-explanatory, from looking on the XSA-100 board itself.
  • PS/2
  • VGA
  • Parallel
Default Jumper Settings
Jumper Setting
J2
On (default)
Off
J6
1-2 (set)
2-3 (osc) (default)
J7
1-2 (default)
2-3
J9
1-2 (xi)
2-3 (xs) (default)
J10 N/A
Descriptions of what each jumper setting does can be found in the documentation.
This document created by: This page created by: CJ Oster and Joe Ngai

Last Modified: April 27, 2003
Please contact Professor Gary Swenson (swenson1@uiuc.edu) to learn more about the course, or contact the webmaster (wiegert@uiuc.edu) with questions or comments about the web site.  Web Site designed by Purvesh Thakker.